Parts from ₹9
3mm Red LED (Through-Hole DIP) – Pack of 10₹15.00₹9.00Out of Stock
1N4007 Diode 1 A 1000 V – Pack of 20₹49.00₹25.00Out of Stock
BC547 NPN Transistor – Pack of 10₹49.00₹25.00Out of Stock
IR Obstacle Avoidance Sensor Module₹79.00₹29.00Out of StockEverything for your first circuit
UNO R3 Board (ATmega328P DIP, CH340G)₹699.00₹399.00Out of Stock
MB102 830-Point Breadboard₹149.00₹69.00Out of Stock
Jumper Wire Set 120 pcs (20 cm)₹199.00₹115.00Out of Stock
5 mm LED Kit 100 pcs – 5 Colours₹149.00₹85.00Out of StockMeasure the world around you
HC-SR04 Ultrasonic Distance Sensor₹149.00₹65.00Out of Stock
DHT11 Temperature & Humidity Sensor₹129.00₹55.00Out of Stock
HC-SR501 PIR Motion Sensor Module₹149.00₹75.00Out of StockIR Obstacle Avoidance Sensor Module₹79.00₹29.00Out of StockTools every maker needs
DT830D Digital Multimeter₹349.00₹199.00Out of Stock
60 W Adjustable Soldering Iron₹599.00₹349.00Out of Stock
Solder Wire 63/37 0.8 mm – 50 g₹299.00₹169.00Out of Stock
DT9205A Digital Multimeter₹699.00₹419.00Out of Stock
DIY Projects
Build your own hardware wallet from an STM32 board, a 0.96" SPI OLED and two buttons, running the open-source Trezor One firmware. Wiring, firmware build, flashing, and setup for BTC in Trezor Suite and ETH/BSC in MetaMask.
Guides & Basics
DIY Projects
